Wall and Walkway Graphics

Available in 3 sizes.  Suitable for indoor use on drywall, concrete, tile, carpet and more.  Slip-resistant. Lasts up to 6 months.  Not intended for in-restaurant use.

INSTALLATION:
1. No heat source is needed to install or remove.
2. Optimal surface temperate for application is 50º Fahrenheit / 10º Celsius or higher.
3. Surface must be completely dry.
4. Sweep surface clean of dirt & debris.
5. For small graphics; remove the release liner, lay adhesive side down flat and press by hand from the center to outer edge, making sure all edges lay flat.
6. For large graphics; pull back 4" of the release liner, align the graphic to the surface and start the application. Continue to remove 6" - 10" of the release liner at a time, using a firm roller or short bristle brush to compress the material, press air bubbles to edges.
7. Use a hard rubber roller to firmly compress to surface. The material should have 100% contact to the surface, especially all edges.

REMOVAL:
1. Peel off at an angle less than 45 degrees for best result; typically leaves no residue.

Keywords: decals, stickers, wall decal, floor decal